Your best friend for file transfer.

FTP uploading stops: OR not recognized--?? (3 posts)
- Started 20 years ago by Jack Andrews
- Latest reply 20 years ago from Jim Matthews
-
Jack Andrews Member
-
Jack Andrews Member
Addendum to my message:
Here is what the Fetch Transcript window displays:
Upload complete at 9/26/03 3:44:22 PM
PORT 172,16,1,33,62,197
200 PORT command successful.
STOR index_08.gif
150 Opening BINARY mode data connection for index_08.gif.
226 Transfer complete.
Upload complete at 9/26/03 3:44:22 PM
PORT 172,16,1,33,8,92
200 PORT command successful.
STOR index_09-index_18_over.gif
500 OR not understood.
ftp_store_setup: -30000 (state == RPUT_SETTING_UP)
ABOR
226 Abort successful
PORT 172,16,1,33,41,63
200 PORT command successful.
STOR spacer.gif
500 OR not understood.
ftp_store_setup: -30000 (state == RPUT_SETTING_UP)
ABOR
226 Abort successfulBTW, Fetch is set to Automatic on both sides
-
Jim Matthews Administrator
I would check the "Use passive mode transfers (PASV)" box in the Firewall section of Preferences. It looks like the STOR command that Fetch sends is being corrupted by your router or DSL modem, so that the server receives "OR" -- which isn't a valid command. Checking PASV should work around this problem, if your server supports PASV.
Thanks,
Jim Matthews
Fetch Softworks
- Page 1
Topic closed
This topic has been closed.
A never-before-seen message stops my uploading process:
"Server response: OR not recognized"
Uploading stops and the message comes back with any subsequent uploading attempts. If I shut down Fetch and start over, I can resume uploading, but it stops again each time with the same message.
The only change lately has been my DSL provider. Using Fetch 4.0.3 on a G4, MacOS 9.22
Posted 20 years ago #